Subwoofer Manual
Manuel de subwoofer
Models: R310d4, R310d2, R312d4, R312d2
Features
Caractéristiques
• Pare-poussière monopièce plaqué aluminum
• Enceinte d’ambiance avec contour en caoutchouc de longue portée
• Anneau de centrage plat à excursion linéaire
• Bobines acoustiques en cuivre exempt d’oxygène à haute température
• Panier rigide en acier
• One Piece Aluminum Plated Dustcap
• Long Throw Rubber Surround
• Flat Non-Linear Roll Spider
• High Temperature OFC Voice Coils
• Rigid Stamped Steel Frame
• Bornes d’enceinte nickelées de calibre 12
• Modèle de moteur à grand battement
• Nickel Plated 12 Gauge Speaker Terminals
• High Excursion Motor Design
Subwoofer Owner’s Manual
system diagrams
Dual 4 ohm Subwoofer
(wired in parallel)
R312d4 SINGLE SUBWOOFER
SYSTEM
R250.1/R500.1 + (1) R312d4
+
-
+
-
All voice coils are wired in parallel for 2 ohm load.
R250.1 and R500.1 make maximum power into 2 ohm load.
Toutes les bobines mobiles sont câblées en parallèle de 2
Ohms. R250.1 et R500.1 faire puissance maximale en 2 Ohms.
Dual 4 ohm Subwoofers
(wired in parallel)
R312d4 DUAL SUBWOOFER
SYSTEM
R1000.1/SD600.1/S1000.1 + (2) R312d4
+
-
+ +
+
-
All voice coils are wired in parallel for 1 ohm load.
Amplifier makes maximum power into 1 ohm load.
-
-
Toutes les bobines mobiles sont câblées en
parallèle pour 1 Ohms. R1000.1/SD600.1/S1000.1
rend la puissance maximale de charge en 1 ohm.
Dual 2 ohm Subwoofer
(wired in series)
R312d2 FOUR CHANNEL
SYSTEM
R300.4 + R65CX 4 ohm stereo front
and R312d2 4 ohm bridged rear
+
-
+
-
R300.4 makes maximum power into a 4 ohm
bridged load. Subwoofer is dual 2 ohm and wired in
series for a final load of 4 ohm.
R300.4 faire puissance maximale en 4 ohm charge
comblé.
-
-
Note: S400.4, Ti600.4, SD500.4 can be substituted
for R300.4 in this system. System wiring is similiar.
+
+
Specifications
T/S Parameters: R310d2
R310d4
1.8
R312d2
.85
R312d4
1.8
Re (Dcr)
FS (Hz)
Sd (SqM)
BL TM
.85
35.3
38.1
30.2
32.7
.033
.033
.05
.05
6.94
8.87
7.63
9.15
Qms
4.49
4.17
4.43
4.68
Qes
.464
.553
.472
.63
Qts
.42
.49
.43
.56
Vas (liters)
Cms (uM/N)
Mms (gms)
SPL
28.13
171.55
118.69
90dB
Dual 2
28.33
172.81
101.14
90dB
Dual 4
55.72
162.84
169.73
90dB
Dual 2
59.78
166.56
142.43
90dB
Dual 4
Impedance
Specifications:
R310d4/2
400 watts
800 watts
30mm
R312d4/2
RMS Power Handling
PEAK Power Handling
Xmax (Peak to Peak)
Mounting Diameter
400 watts
800 watts
30mm
9 1/4in - 235mm 11 1/8in - 282mm
Mounting Depth
5in - 129mm
5 1/4in - 134mm
*Specifications subject to change
Phoenix Gold
A Division of AAMP of America™
13190 56th Court
Clearwater, Florida 33760
P: 866-788-4237
© 2011 AAMP of Florida, Inc
Designed and Engineered in the USA
LIMITED WARRANTY
Phoenix Gold warrants this product to be free of defects in materials and workmanship for a period of one (1) year from the original date of purchase. This
warranty is not transferable and applies only to the original purchaser from an authorized Phoenix Gold dealer in the United States of America only. Should
service be necessary under this warranty for any reason due to manufacturing defect or malfunction, Phoenix Gold will (at its discretion), repair or replace the
defective product with new or remanufactured product at no charge. Damage caused by the following is not covered under warranty: accident, misuse, abuse,
product modification or neglect, failure to follow installation instructions, unauthorized repair attempts, misrepresentations by the seller. This warranty does not
cover incidental or consequential damages and does not cover the cost of removing or reinstalling the unit(s). Cosmetic damage due to accident or normal wear
and tear is not covered under warranty.
INTERNATIONAL WARRANTIES:
Products purchased outside the United States of America are covered only by that country’s Authorized Phoenix Gold reseller and not by Phoenix Gold.
Consumers needing service or warranty information for these products must contact that country’s reseller for information.
|