Pelco Recording Equipment RMJ9UCA User Manual

C937M

INSTALLATION MANUAL

MODEL RMJ9UCA RACK MOUNT KIT

1.0 SCOPE

3.0 SPECIFICATIONS

Theinformationwithinthismanualcoverstheinstal-

lation of the RMJ9UCA Rack Mount Kit.

Dimensions:

Construction:

Weight:

See Figure 1

16-gauge steel

5 lbs 4 oz.

Installation should be in accordance with all appli-

cable local and national electric codes, utilizing

approved materials only.

4.0 INSTALLATION

1. Remove rubber feet on front bottom of monitor.

Please thoroughly familiarize yourself with the infor-

mation in this manual prior to installation and opera-

tion.

2. Install monitor through rear of rack, placing rear

rubberfeetonmonitorintolocatingholesinfloor

or rack.

3. Install rack and monitor as an assembly into

console and make any required electrical con-

nections.

2.0 DESCRIPTION

The RMJ9UCA Rack Mount Kit is designed to pro-

viderackmountingforsingleordualPELCOPMC09A

and PMC09A-X 9" monitors.

4. Hold into place, aligning mounting holes of the

RMJ9UCA with mounting holes in console, and

insert and tighten required fasteners (not sup-

plied). If only a single monitor is used, install

cover plate up against window frame and then

insert fasteners and tighten.

This versatile rack will fit any standard 19-inch wide

console or rack configuration.

NOTE: VALUES IN PARENTHESES ARE CENTIMETERS; ALL OTHERS ARE INCHES

Figure 1. RMJ9UCA Dimension Drawing

PELCO Manual C937M - 1/96